MINIMUM STANDARD FEATURES FOR CUSTOM HOMES

Exterior and Energy:

• Custom floor plan design
• All required permitting, including septic design and system installation
• Engineered to meet or exceed windstorm and all other applicable building requirements
• Radiant barrier roof decking
• R30 Insulation in attic
• R19 insulation in all exterior walls and floor
• 13 SEER central air and heat
• Stainless steel nails used in exposed locations
• James Hardie products for siding, trim and soffits
• Impact resistant low-E vinyl windows
• Impact resistant low-E fiberglass entry door with full-view glass and stainless hinges
• Sherwin Williams paint inside and out
• 30 year warranty architectural shingles
• 8’ of patio deck
• Concrete slab under footprint of house as permitted by code
• Third party foundation engineering and windstorm inspections
• Pressure blocking and bridge blocking

Interior:

• Raised panel doors as per customer selection
• 9’ ceilings
• Vinyl flooring in kitchen, bathrooms and utility room
• Carpet in living areas and bedrooms
• Full utility room (washer/dryer) as per plan
• All closets contain light with switch
• smoke detectors
• low flow elongated commodes
• Custom paint grade cabinetry in kitchen and baths
• Formica counter tops with stainless steel sink
• Range, microwave vent-a-hood and dishwasher
• Ceiling fans with light kits in living room and all bedrooms
• Cable TV outlets in living room and master bedroom
• Telephone wiring in kitchen and master bedroom

*Upgrades as per customer request